The medium-pressure regulator, specially manufactured for the Purivox scare devices, can be equipped with the following three connections (see images on the left).KLF Regulator - suitable for German gas cylindersPOL Regulator - suitable for international gas cylindersSHELL Regulator - suitable for Swiss gas cylindersA: Thread designationB: Hexagon wrench sizeC: Length of union nutD: Diameter of inner pin Image sources: GOK Regler- und Armaturen-Gesellschaft mbH & Co. KG

With the old housing cover it can come in rare cases to the fact that the holding spigots break off after longer operating time. This may cause the cover to lift off from the housing in strong winds and storms. As a result, rain and moisture can damage the electronics.We offer you a conversion to our new cover. For this purpose you can send us the device and we will carry out the conversion for you.However, you can also easily do this conversion yourself with a few simple steps.In this case we have prepared a conversion instruction and the corresponding drawing  for you to download. Instruction (German)

We have included all of your required needs in the development of our blast-shock control units. 3-way shot for effective expulsion (scare – fly up – fly away) Irregular firing sequences. Random configuration in four time sequences prevents birds adapting to  sound. Timer installed. Operation Freedom, greater programmable random configuration, pre-set on and off timer. Optimized power consumption. Long-term operation without battery replacement. Weatherproof housing. Prevents interference from rain or condensation.   The Micro-controller regulates the propane gas,via a solenoid valve, into the firing chamber, combustion then takes place by means of high voltage ignition. All components are moisture protected and the power consumption is optimized, all of which gives for a long service life. Energy needs:  2 x 6V 4R25 batteries.

These instructions will help you to install and connect your new digital 12V timer for a Purivox gas cannon. Please follow each step carefully. remove the old cables from the built-in timer using a small screwdriver.remove the built-in timer by pulling the small white tab away from the timer and lifting it carefullyconnect the cables to the new digital timer as shown on the diagram below.cables 1 and 2 are for the ON/OFF switchconnect cable 3 to slot 3 of the time switchcable 4 together with cable 6 (brown) to slot 4cable 5 (blue) to the GND slotnow carefully plug the time switch back onto the mounting railTo set the time switch, you can either do this directly via the time switch or using the Save*n Carry app. You will need an NFC-enabled smartphone for this.If you need help with the setting, please do not hesitate to contact us.

With the help of the external battery connection cable, the Purivox bang alarm devices can be supplied with power very easily via a 12V car battery.Installation instructions (If you order the item at a later date. In the case of a new device and the optional external battery connection cable, this is already installed).You will need the following tools: Drill 4mm and 10mm M12 tap Drill a 4mm hole in the centre below the on/off switch and the sticker. Then drill it out to 10mm. Use the thread cutter and cut an M12 thread into the front.CAUTION: Be careful not to damage the circuit board.Now insert the plug and the cable through the hole and tighten the cable gland. Now plug the white connector onto the circuit board.You can now operate your firecracker with any standard 12V battery. If you have any questions, please do not hesitate to contact us.