Light sensor
Installation of phototransistor in electronic unit
- Ø 8.2mm drill bit
- Place electronic unit with opening to the right and cable to the front
- Drill the housing (be careful with the cable!)
- Insert the grommet DA 48/80/30 (105871)
Uplexa 08 version (light sensor article no. 105225)
- Remove the cable between ‘Opt’ and ‘Man’ on the Uplexa 08 circuit board
- Plug the phototransistor cable onto the circuit board (white - left / yellow - right) Version Uplexa 08
Uplexa 19 version (light sensor article no. 105226)
- Plug the connector onto the connector shown below for the Uplexa 19 version
For both versions, the phototransistor must protrude a little from the DA 48/80/30 grommet.
If you have any questions, please contact us directly!